![]() ![]() ![]() It's designed to work with another pricey piece of software you have to buy from them. The raw mode would be good if it integrated with lets say Lightroom but it doesn't. Besides a rather useless raw mode it doesn't have 48 bit per colour save function. If you have any form of workflow the Silverfast software is a piece of junk you would have to spend at least the cost of a scanner to upgrade to a usable version. No digital ICE (not really a problem for me as I don't use it anyway and it doesn't work on B&W) This is not really a problem as I hand correct every negative Manual feeder so after you load the carrier you have to push it through by hand one frame at a time. Scanning is done through the included Silverfast Se plus software. So far, the only problem I have been able to detect is the USB 3 connectability.Well priced alternative to a flatbed scanner.7200 dpi scanner (when measured with a target it turns out to be 3800 dpi in both directions which is right in Nikon cool scan territory)Īctual Dmax > 3.6 and can be increased through multiple exposure mode. Obviously all those concerns have been observed. In case it is not present, please check the cable connection.įor further information, please visit our support system. ![]() Please make sure that your scanner is shown in the Windows device manager, without any warnings. When using USB make sure the scanner is connected directly. Please make sure your scanner is connected and turned on. SilverFast was not able to detect any scanner supported by your installed scan module. Here is the message upon starting up SilverFast: The Device Manager in Win 10 indicates that the best driver has been installed and there are no problems. I spent more than 8 hours updating anything that might be needing an update on this new laptop. I have an USB 2 hub but no direct USB 2 port. Windows tells me that the scanner is unable to work with USB 3 port and I should try USB 2 instead. I am using Win 10 and a new Dell XPS 1500 laptop. I can scan with the scanner from the windows device manager/device driver itself but not from SilverFast. I installed the latest updates for the program as well as the scanner. SilverFast does not recognize my Plustek 7400 scanner. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |